Fasten Aluminum Bathing Ladder For Boats And Inflatable Boats (Ø 32 Mm – Max. 140 Kg)
The Fl032 is a bathing ladder for your inflatable boat. It is installed on two brackets, which must be at a distance of 305 mm from each other. The ladder can be bent in 3 places, so when not in use it can be folded up so far that the ladder is no longer in the water. The brackets do not even have to be loosened. This is very practical because the ladder can be made ready for use very quickly.
Thanks to the articulated joints it adapts perfectly to the hose of your inflatable boat and is therefore suitable for all hose diameters (Ø). Once attached to the bracket, you can hold onto the top aluminum tube and pull yourself up.
Finally a ladder where getting in and out really works without any problems. This makes it perfect for older people.
This bathing ladder has a Ø (diameter) of 32 mm, the joints are made of polyamide. You can easily loosen or screw the joints by hand. The hand nut and a stainless steel bolt make it possible without any tools.
ATTENTION:It is recommended that the boat remains stable when boarding to install the bathing ladder on the sides or on the bow (front) of your boat. If the engine and the ladder have both been mounted at the stern (rear), you should make sure that there is sufficient counterweight in the bow.
There is also a swimming ladder with a smaller tube diameter (Ø ). People up to 100 kgand has the article number:Fl022
|Country of manufacture
|Length x width x height
|1007 × 431 × 78 mm
Black/Aluminum-Black, Black/Aluminum-Silver, Gray/Aluminum-Silver