Fasting 1 X Rods And Tube Joint (Collar Plug) For (Ø 22 Mm) E.G. For Bimini
This fasting accessory holds a tube with a Ø (diameter) of 22mm. One side has a collar with which the pipe is held and the other side has a plug that is attached to the cut end of the aluminum pipe. After the plug has been sunk into the pipe, it should be fixed with a pin. The plug already has a hole for this purpose. This is used in the construction of tubular frames, as is the case, for example, with a bimini or a fabric roof construction. Fasten himself uses this joint in his support stand equipment carrier such as St080. It can be tilted 180 ° to the side.
The joint is attached to the round tube using riveting pliers and two blind rivets. There are two holes on the joint for inserting a blind rivet and fastening it with the riveting pliers. If you want to remove the rivet again, it has to be drilled through.
The same article is also available for other Ø (diameter):
- Ø (diameter) 32 mm: 1 pieceSingle pack: Tf032
- Ø (diameter) 32 mm: 2 pieces double pack: Tf032-2
Height: when plugged in 55 mm
The same article is also available in a 2-pack (reduced price), article number: Tf022-2
- for holding pipes with Ø (diameter) 22 mm
- 180 ° tiltable
|Country of manufacture||Ukraine|
|Net weight||53 g|
|length x width x height||82 × 53 × 35 mm|
White, Black, Gray
There are no reviews yet.