Fasting 2 X Rods And Tube Joint (Collar Plug) For (Ø 32 Mm) E.G. For Bimini


Reference Tf032-2

This product fits the following boats

How to assemble this product

Product type


This fasting accessory holds a tube with a Ø (diameter) of 32 mm. One side has a collar with which the 32 mm tube is held and the other side has a plug that is attached to the cut end of the aluminum tube. Plug dimensions outside 27 mm inside 20 mm.
After the plug has been sunk into the pipe, it should be fixed with twoblind rivets.

The joint is fastened using arivet pliersand two blind rivets attached to the round tube. There are two holes on the joint to insert a blind rivet and fasten it with the rivet pliers. If you want to remove the rivet again, it has to be drilled through.

It is used in the construction of tubular frames, as is the case with abimini or a fabric roof construction Fasten himself uses this joint in his support stand equipment carrier such as St080.

It can be tilted 180° to the side and fixed with the hand screw. The collar end can be rotated 360° and cannot be fixed (so that it stops rotating).

The same article is also available for other Ø (diameter):

  • Ø (diameter)22 mm: 1 piece
Art.-ID 275
Status New
Manufacturer Fasten
Country of manufacture Ukraine
Contents 1 piece
Weight 242 g
Net weight 242 g
Length x width x height 115 × 56 × 35 mm

Black, Gray


There are no reviews yet.

Be the first to review “Fasting 2 X Rods And Tube Joint (Collar Plug) For (Ø 32 Mm) E.G. For Bimini”

Your email address will not be published. Required fields are marked *